IRIG106wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
~~ODT~~
===== DISCRETE DATA =====

==== Type 0x28, Discrete Data, Format 0 ====

Reserved for future use. 

----

==== Type 0x29, Discrete Data, Format 1 (Discrete Data) ====

Discrete Data, Format 1 packets are 
used to record the state of discrete digital signals. In general, the discrete data packet will 
contain multiple values from multiple discrete events. 
 
The layout of the CSDW is shown in Figure 6-32. The uRecordState and 
uAlignment flags are components of the discrete packet Mode field. See the Chapter 10 
standard for further details. The uLength value is the number of Discrete Data message that 
follow in the packet. 

<code> 
struct SuDiscreteF1_ChanSpec 
    { 
    uint32_t    uRecordState    :  1;   // Record on state/time 
    uint32_t    uAlignment      :  1;   // Data alignment 
    uint32_t    uReserved1      :  1;   // 
    uint32_t    uLength         :  5;   // Number of bits 
    uint32_t    uReserved2      : 24;   // 
    }; 
</code>
 
<html><center><b>
Type 0x29 Discrete Data Format 1 CSDW
</b></center></html>

The layout of the Discrete Data message is shown in Figure 6-33. Each message contains 
a time stamp and the state of the discrete data input signals. The suIntraPckTime field in 
the data structures of represents event time in either 48-bit relative time format derived from the 
RTC (format shown in Figure 6-5) , or as absolute time. If this time is absolute time, it is in 
either Chapter 4 weighted 48-bit time (format shown in Figure 6-6) or IEEE 1588 time format 
(format shown in Figure 6-7). 

<code> 
struct SuDiscreteF1 
    { 
    uint64_t    suIntraPckTime;         // Intra-packet time stamp 
    uint32_t    suData;                 // Data about the event 
    }; 
</code>

<html><center><b>
Type 0x29 Discrete Data Format 1 message
</b></center></html>

The IRIG 07 Chapter 10 and prior standard incorrectly states that Bit 7 of the Packet 
Flags (in the packet header) is used to determine if the intra-packet time is relative time or 
absolute time. The correct bit to use is Bit 6. It is anticipated that with will be corrected in a 
future release 

----

==== Type 0x2A - 0x2F, Discrete Data, Format 2 - Format 7 ====

Reserved for future use.